Pressing Instructions
Thank you for your purchase!
You'll find all the pressing instructions for our products here, as well as in each listing. Any questions, feel free to contact us!
DTF Transfers
Pre-Press Garment for 10 seconds to get out any moisture.
Temp: 325°F
Pressure: Heavy (if print doesn't stick, more than likely its due to not enough pressure. Make sure your press is on heavy pressure!)
Time: 20 Seconds
Peel: Cold
Do not cover with any Teflon etc. If print needs an additional press, please use parchment paper over it.
Temp: 325°F
Pressure: Heavy (if print doesn't stick, more than likely its due to not enough pressure. Make sure your press is on heavy pressure!)
Time: 20 Seconds
Peel: Cold
Do not cover with any Teflon etc. If print needs an additional press, please use parchment paper over it.
*Please note the time and temp are suggested and you may have to adjust based on your own presses best settings.
Tumbler Sublimation Prints
Sublimation Transfers are recommended to be applied with a convection oven.
For 20oz Skinny Straight Tumblers
TEMP: 350-360° degrees
PRESS TIME: 6-7 Minutes
TEMP: 350-360° degrees
PRESS TIME: 6-7 Minutes
TURNING TIME: 1/2 Way
Glass Can Sublimation Prints
For 16oz Glass Can/Beer
TEMP: 350°-400° degrees
PRESS TIME: 6-8 Minutes
TEMP: 350°-400° degrees
PRESS TIME: 6-8 Minutes
TURNING TIME: 1/2 Way
UV DTF WRAPS & DECALS
*No cup press is required*
1. Peel design transfer off of backing.
2. Place the transfer on the cup ensuring design is straight and positioned correctly.
3. Press the transfer down, working from the center outwards, pushing out any bubbles.
4. With fingers, Rub the Design Transfer. The more you rub the better.
5. Peel clear film off and you're done!
Hand wash only!
*We do not advise to put in dishwasher or microwave*
We are not responsible for application errors.
*Please note: Not all brands of 16 oz. glass cups have the exact same size.
Our wraps have been measured to fit Libbey Glass Cans.
Welcome to your New cup addiction!